Topcon SR-NIR, Инструкция по эксплуатации

Страница: 50 / 86

38
3.7 Data Communication Method
In this instrument, there are two methods to output the measurement data.
One method is provided to communicate with the remote measurement tool, which is the
communication software as the accessory of this instrument. In the case of this method, handshaking
is performed to check data errors. (Handshake Type)
In the case of the other method, data are sent continuously from the first to the last. (Normal Type)
The details of communication will be explained in the section of ST command of the chapter about
communication command.
In this chapter, the setting method in the function mode will be described.
Note
When “USB” is set in “3.5 PC Connection Method”, the setting screen for the data
communication method is not indicated.
1. Shift to the function mode. Access [COMM.]
from the function menu. Then, access the
[Handshake ON/OFF] screen.
☞
“3.1.2 Entering/Returning from the Function Mode”
2. Press the [CHANGE] switch.
3. Press the [ROTATION] switch to select the desired method.
Each time you press the [ROTATION] switch, the display is changed as shown below.
Handshake Type
→ Normal Type
4. After selecting, press the [ENTER] switch.
ENTER
DIF.
ABS.
UP
LAMP
DOWN
MEAS.
HOLD
FIELD
CHANGE ROTATION
SHIFT
FUNCTION
＊ Ｈａｎｄｓｈａｋｅ ＯＮ／ＯＦＦ ＊
＊Ｎｏｒｍａｌ Ｔｙｐｅ
＊ Ｈａｎｄｓｈａｋｅ ＯＮ／ＯＦＦ ＊
＊Ｈａｎｄｓｈａｋｅ Ｔｙｐｅ
ENTER
DIF.
ABS.
UP
LAMP
DOWN
MEAS.
HOLD
FIELD
CHANGE ROTATION
SHIFT
FUNCTION