Topcon SR-NIR, Инструкция по эксплуатации

Страница: 48 / 86

36
3.6 RS-232C Parameters
Set the parameters of RS-232C interface. This setting is necessary when connecting the instrument
to PC through the RS-232C cable.
Set the RS-232C parameters in the function mode.
In the following example, “Baud rate: 9600, Data length: 8, Parity: None, Stop bit: 2” will be changed to
“Baud rate: 38400, Data length: 7, Parity: Odd number, Stop bit: 1”.
The setting procedures are described below.
Note
When “USB” is set in “3.5 How to Connect PC”, the RS-232C parameters setting screen is
not indicated.
1. Shift to the function mode. Access [COMM.]
from the function menu. Then, access the
[RS-232C Parameters] screen.
☞
“3.1.2 Entering/Returning from the Function Mode”.
2. To set the parameters, press the [CHANGE] switch. The part of the parameters, which can
be changed, blinks.
3. Press the [ROTATION] switch to change the baud rate to 38400.
Baud rate is changed in the following order.
38400
→
4800
→
9600
→
19200
ENTER
DIF.
ABS.
UP
LAMP
DOWN
MEAS.
HOLD
FIELD
CHANGE ROTATION
SHIFT
FUNCTION
＊ＲＳ－２３２Ｃ Ｐａｒａｍｅｔｅｒｓ＊
Ｂａｕｄ ｒａｔｅ＝ ９６００
Ｌｅｎｇｔｈ＝８ Ｐａｒｉｔｙ＝ＮＯＮＥ
Ｓｔｏｐ ｂｉｔ＝ ２
ENTER
DIF.
ABS.
UP
LAMP
DOWN
MEAS.
HOLD
FIELD
CHANGE ROTATION
SHIFT
FUNCTION
＊ＲＳ－２３２Ｃ Ｐａｒａｍｅｔｅｒｓ＊
Ｂａｕｄ ｒａｔｅ＝ ９６００
Ｌｅｎｇｔｈ＝８ Ｐａｒｉｔｙ＝ＮＯＮＥ
Ｓｔｏｐ ｂｉｔ＝ ２
＊ＲＳ－２３２Ｃ Ｐａｒａｍｅｔｅｒｓ＊
Ｂａｕｄ ｒａｔｅ＝ ９６００
Ｌｅｎｇｔｈ＝８ Ｐａｒｉｔｙ＝ＮＯＮＥ
Ｓｔｏｐ ｂｉｔ＝ ２
ENTER
DIF.
ABS.
UP
LAMP
DOWN
MEAS.
HOLD
FIELD
CHANGE ROTATION
SHIFT
FUNCTION