Topcon HiPer V, Руководство оператора

Страница: 60 / 122

Configuring the Receiver
POWERUP Script Requirements
47 P/N: 1001608 ‐ 01
POWERUP Script Requirements
After turning on the receiver, the POWERUP script executes when the receiver obtains valid position coordinates and the
following requirements are satisfied.
•
The POWERUP script has been installed to receiver.
•
The POWERUP script function setting is ON.
•
The receiver is not starting by using the timer.
•
There is no enabled job/session.
Installing the POWERUP Script
To install the POWERUP script onto the HiPer V receiver:
1. Copy the POWERUP script file “ powerup.gcs ” to the “POWERUP” folder on the SD card.
2. Insert the SD card into HiPer V receiver.
3. Perform a Factory Reset on the HiPer V.
4. Once the installation is successful, the “ powerup.gcs ” file is removed from the SD card.
If the file attribution is Read only, the file will not be not removed.
If there is the existing POWERUP script on the HiPer V, it will be overwritten by the new script file.