Topcon HiPer V, Руководство оператора

Страница: 44 / 122

Managing P
o
wer
Batteries
31 P/N: 1001608 ‐ 01
Charging the Batteries
When the battery charge is low, the Available Power Bar changes from solid green to yellow to red and then blinking red,
depending on the remaining charge (see “Available Power Bar” on page 20). When the receiver is connected to an external
power source, the battery does not charge and becomes disabled from supplying power to the receiver.
To charge the battery, use the supplied charger. It takes approximately 4 hours to completely charge one battery and 8
hours to completely charge two batteries. The Li ‐ Ion batteries used in the battery packs should run at no less than 80%
capacity after 500 charging cycles. You do not need to drain the batteries before recharging .
To charge the batteries:
1. Connect the power cable to the charger and plug the charger into the wall outlet.
The batteries are shipped from the factory with a partial charge. For maximum operating time, fully charge the
batteries before using the receiver.