Topcon GB-500, Руководство оператора

Страница: 70 / 120

Operation and Data Management
Topcon GB-500 Operator’s Manual
3-24
6. Click the Program tab and set the Capture Method to Soft
Break Capture (recommended) (Figure 3-23).
Figure 3-23. Program Tab Settings
7. Browse for and select the receiver board’s RAM and Flash
files (Figure 3-23).
8. Click Load and wait until 100% of the files load into the
receiver.
NOTICE
NOTICE
If you selected an incorrect RAM or Flash file, an error
message displays at the bottom of the dialog box.
Reselect the correct file.
9. Click File Exit.
10. Clear the receiver’s NVRAM (see “Clearing the NVRAM”
on page 3-19) and update the almanac (see “Collecting
Almanacs” on page 2-17) after loading new firmware.
Note on COCOM Restriction
The GB-500 will stop the calculation of any position and speed, as
well as the output and recording of any observation data, if it
exceeds the range specified by COCOM (if the moving velocity of
the GB-500 exceeds 1,000 knots or its altitude exceeds 18,000
meters).