INSTALLATION INSTRUCTIONS FOR
EXIT SIGN AND EMERGENCY LIGHT COMBO UNIT
IMPORTANT SAFEGUARDS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. Review instruction sheet before beginning installation.
2. All electrical connections must be in accordance with local codes, ordinances, and the National
Electric code.
3. Disconnect power at fuse or circuit breaker before installing or servicing.
4. Not for outdoor use.
5. Do not mount in hazardous locations, or near gas or electric heaters.
6. Do not let power cords touch sharp or hot surface.
7. Equipment should be mounted in locations and at heights where it will not be subjected to
tampering by unauthorized personnel.
8. The use of accessory equipment not recommend by the manufacturer may cause an unsafe
condition.
9. Do not use this equipment for other than intended use.
10.All servicing should be performed by a qualified electrician only.
11. Allow battery to charge for 24 hours before first use.
use Flexible conduit only
SAVE THESE INSTRUCTIONS
MAINTENANCE
Equipment must be tested regularly in accordance with local codes. Replace the batteries as needed according to ambient
conditions. No other maintenance required.
OPERATION
Depress test button. The LED heads will turn on and the LED indicator will turn off. Release test button, LED indicator will
turn on and LED heads will turn off.
TROUBLE SHOOTING GUIDE
If LED heads or LED indicator do not illuminate, check the following:
1. Check AC supply - verify that unit has 24 hours AC supply.
2.
W
iring is shorted or battery is not connected.
3. Battery discharge. Permit unit to charge for 24 hours then re-test.
4. If above trouble shooting does not solve the issue, contact manufacturer for assistance.
Page 1 of 2
www.topaz-usa.com
• 925 Waverly Ave • Holtsville, NY 11742 • 800-666-2852 • Fax: 631-758-8026
Items: ESC/LED/RW-NYC
EXIT SIGN AND EMERGENCY LIGHT COMBO UNIT
INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS FOR
EXIT SIGN AND EMERGENCY LIGHT COMBO UNIT
IMPORTANT SAFEGUARDS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. Review instruction sheet before beginning installation.
2. All electrical connections must be in accordance with local codes, ordinances, and the National
Electric code.
3. Disconnect power at fuse or circuit breaker before installing or servicing.
4. Not for outdoor use.
5. Do not mount in hazardous locations, or near gas or electric heaters.
6. Do not let power cords touch sharp or hot surface.
7. Equipment should be mounted in locations and at heights where it will not be subjected to
tampering by unauthorized personnel.
8. The use of accessory equipment not recommend by the manufacturer may cause an unsafe
condition.
9. Do not use this equipment for other than intended use.
10.All servicing should be performed by a qualified electrician only.
11. Allow battery to charge for 24 hours before first use.
use Flexible conduit only
SAVE THESE INSTRUCTIONS
MAINTENANCE
Equipment must be tested regularly in accordance with local codes. Replace the batteries as needed according to ambient
conditions. No other maintenance required.
OPERATION
Depress test button. The LED heads will turn on and the LED indicator will turn off. Release test button, LED indicator will
turn on and LED heads will turn off.
TROUBLE SHOOTING GUIDE
If LED heads or LED indicator do not illuminate, check the following:
1. Check AC supply - verify that unit has 24 hours AC supply.
2.
W
iring is shorted or battery is not connected.
3. Battery discharge. Permit unit to charge for 24 hours then re-test.
4. If above trouble shooting does not solve the issue, contact manufacturer for assistance.
Page 1 of 2
