3
www.topazsystems.com
SigWeb Installation Guide
Steps
SIGWEB MUST BE RUN IN AN ELEVATED COMMAND PROMPT AS AN ADMINISTRATOR.
FOLLOW THE STEPS BELOW EXPLICITLY TO DO THIS FOR PROPER INSTALLATION.
First-Time Install Steps
Follow Steps 1-5 here if you have never installed SigWeb before:
1. Download SigWeb based on your pad model (listed on the back of your Topaz signature
pad). Follow the steps from the correct option below, and then continue with Step 2.
a.
If your Topaz signature pad model
ends in “-HSB-R”, “-BHSB-R”, or “B-R”
,
download SigWeb from the following link:
www.topazsystems.com/software/sigweb.exe
. Once downloaded, do not yet
run it. Copy the .exe. from its download
location and move it directly into the “C:”
folder on your computer.
b.
If your Topaz
signature pad model ends in “-BSB-R” or “-BBSB-R”
,
download SigWeb BSB from the following link:
www.topazsystems.com/software/sigwebbsb.exe
. Once downloaded, do not
yet run it. Copy the .exe. from its download location and move it directly into the
“C:” folder on your computer.
2. Before installing, be sure to close all open browsers (i.e. Chrome, Firefox, Internet
Explorer, etc).
3.
Click on “Start”
“All Programs”
“Accessories”. Right-click on “Command Prompt”
and choose “Run As Administrator” to open an elevated command prompt window.
