Tonny TE1-0601 Скачать руководство пользователя страница 1

Automatic Soap Dispenser User Manual

Features

Model:TE1-0601

1

5

3

4

6

2

1. Spout                                                           2. Infrared sensor sender
3. Battery compartment
4. On/Off Switch & Liquid Soap Volume Control
5. Container lid                                             6.Blue LED indicate

Installation

 
· Open cover on battery compartment, and install 3 
“AA”batteries with correct polarity(Note the +/- 
indication)
· Open the soap container (Figure 1)
· Fill with liquid soap
· Ensure that soap container is closed with the disprn-
ser.(Figure 2) 
· To turn on, press on the power button and adjust 
the soap volume control to the setting what you 
requirement
· Put your hand under the sensor within 0-2 inch to 
let the dispenser start to work. 

Operation

 
The on/off switch is located on the machine top
It is a three position switch:
·Press once- Blue led light flashes 1 time then off and     
indicates power on and in use with low volume liquid 
soap; LED will flicker in dispensing
·Press twice- Blue led light flashes 2 times then off 
and indicates power on and in use with high volume 
liquid soap; LED will flicker in dispensing
· Press 3rd time- Power off

Notice: For first time use, press once, then press on the 
button till the soap drops 

Attention
· Place the dispenser on a flat, level surface.
· This product is for indoor use. Exposure to direct 
sunlight will destroy the sensor system.
· Use liquid soap with a low concentration of alcohol.
· Avoid placing this product in areas where it could 
become covered in water.
· Keep the liquid clean.
· If you will not be using the dispenser for an extended 
period of time, empty the container of soap, clean the 
dispenser out and remove the batteries. Store it in a dry 
place.
· Do not subject the On/Off switch to too much 
exposure to water.

Recommended Usages:

 
· Use non-granular, non-foaming liquid soap or 
hand sanitizer.
· Clean dispensing tip regularly and run pump with 
warm water solution.
· Not to be used with rechargeable batteries.

Battery Low Indication

 
·If LED continues to flash blue the indication is 
positive to replace the batteries.

Technical Date

Figure 1

Figure 2

Dimension 
Vol 
Unit weight 
Plastic Material 
Battery type 
Rated Voltage 
Sensor Range 
Waterproof 

L96*W105*H227mm/ L3.8*4.1*8.9 in

380mL /12.8 oz

320g / 0.68 lb

ABS

3 X 1.5V “AA” Alkaline

4.5V

0-5cm / 0-2 in.

IP X4

Отзывы: