Tonghui Electronics TH7105, Руководство по эксплуатации

Страница: 27 / 187

22

F HiLmt
1) Description
This parameter is used to set the high limit of output frequency. Its range is 45.0~500.0Hz.
2) Operation
Make use of the

key or the knob to move the cursor to this parameter option, then change it
through the front panel numeric keys, then press ENTER or OK to confirm the change. If you do not
want to change the parameter value or press the wrong numeric key, you can cancel it by pressing the

key or ESC key.

F LoLmt
1) Description
This parameter is used to set the low limit of output frequency. Its range is 45.0~500.0Hz
2) Operation
Make use of the

key or the knob to move the cursor to this parameter option, then change it
through the front panel numeric keys, then press ENTER or OK to confirm the change. If you do not
want to change the parameter value or press the wrong numeric key, you can cancel it by pressing the

key or ESC key.

On PHS
1) Description
This parameter is used to set the staring phase angle of output waveform. Its range is 0~359
°
.
2) Operation
Make use of the

key or the knob to move the cursor to this parameter option, then change it
through the front panel numeric keys, then press ENTER or OK to confirm the change. If you do not
want to change the parameter value or press the wrong numeric key, you can cancel it by pressing the

key or ESC key.

Off PHS
1) Description
This parameter is used to set the ending phase angle of output waveform, its range is 0~359
°
.
2) Operation
Make use of the

key or the knob to move the cursor to this parameter option, then change it
through the front panel numeric keys, then press ENTER or OK to confirm the change. If you do not
want to change the parameter value or press the wrong numeric key, you can cancel it by pressing the

key or ESC key.

Results
1) Description