Tohnichi R-BL, Руководство по эксплуатации

Страница: 18 / 28

16
7 Setting Receiver
7-1 Setting Receiver
As a default setting, BL Receiver receives all signals of BL Transmitter, T-BLA to R-BLA, T-BLE to
R-BLE and T-BL to R-BL. Refer to 7-2, Setting Procedure. ID registered receiver does not receive any
other ID signal. Up to 10 Transmitters can be registered to one receiver. Total 4 IDs o
utput as
non-voltage contact signal and RS232C output. Other 6 IDs output through RS232C only.
OUT1 to OUT4 Register IDs on OUT1 to OUT4
OUT1 to OUT4 outputs ID through contact output and RS232C.
RS1 to RS6 Register IDs on RS1 to RS6
RS1 to RS6 outputs ID through RS232C
Flow Control Select ON/OFF of CTS, RTS control
Baud Rate Select one from 2400, 4800, 9600, 19200, 38400, and 115200bps
Parity Select one from NONE, ODD, and EVEN
Data Length Select one between 7 and 8bit
Stop Bit Select one between 1 and 2bit
Buzzer Sound Select ON/OFF of buzzer sound
Auto Reset Timer Select between 0.0~9.9 seconds
Since R-BL does not receive any signal during the auto reset process, this
function also can be used as double count prevention
Auto reset function will be disabled if set as 0.0 second. In this case, reset can be done only
through reset input or through reset command.
Factory Default
Item
OUT1
to
OUT4
RS1
To
RS6
Flow
Control Baud Rate
Parity
Data
Length
Stop Bit Buzzer
Auto
Reset
Timer
Status Off 115200bps NONE 8bit 1bit ON 0.1 Sec