6
6. SPEAKER STAND FOR SR-F1D
The speaker stand manufactured by Köning & Meyer GmbH (K & M) of Germany is made available for use with
TOA's SR-F1D speaker.
The speaker stand consists of two main sections, which are sold separately.
Stand:
Model 213
Stand bracket: Model 195/8
Step 1. Extend the stand's legs.
Loosen the tripod fixing screw and open the tripod
legs outward so that the stays become level.
Then, tighten the fixing screw.
Step 4. Adjust the stand height.
4-1. Loosen the height fixing screw.
4-2. Loosen the handle fixing screw and raise the handle,
then retighten the handle screw.
4-3. While holding down the lock button, adjust the
speaker's height by turning the height adjustment
handle. (Clockwise rotation raises the speaker.)
Note
You cannot rotate the handle unless the lock button
is continuously pressed. To complete the height
adjustment, ensure that the shaft is locked when
the lock button is released. (This can be checked by
rotating the handle slightly.)
Step 5. Retighten the height fixing screw.
Note
Leave the handle folded back except when adjusting the height.
Step 2. Attach the stand bracket to the speaker using the
speaker mounting screws and plain washers.
Step 3. Loosen the bracket fixing screw, then place the
speaker on the stand.
After setting the speaker's orientation, retighten the
bracket fixing screw.
Fully extend the stand’s tripod legs and place
the stand on a stable surface. If the tripod is not
sufficiently extended, the stand could topple over,
possibly resulting in personal injury.
WARNING
Owing to the speaker’s size and weight, be sure
that at least two persons are available to install the
speaker. Failure to do so could result in personal
injury.
WARNING
Height fixing screw
Tripod fixing screw
Tripod leg
Stay
Lock botton
Handle fixing screw
Height adjustment
handle
Plain washer (for M8)*
Speaker mounting screw
M8 x 20*
Stand 213
SR-F1D
Stand bracket
195/8
1
2
3
4, 5
Bracket fixing
screw
* Prepare separately.
Plain washer (for M8):
2 pcs
Speaker mounting screw M8 x 20: 2 pcs
