Toa NX-300, Руководство по установке

Страница: 176 / 183

Chapter 6
APPENDIX
STATUS BUSY RUN ERROR 2 1 2 1 SD CARD RESET
OUTPUT INPUT
LNK/ACT
VOLUME
1 2
00-05-F9-FF-80-81
NETWORK AUDIO ADAPTER NX-300
2. INDICATOR STATUS AND TROUBLESHOOTING
Indicator status:
Unlit Lighting, Flashing,
1. Input indicator (Green)
Input signal level high enough for network
transmission
Input signal distorted
Input signal reaching clipping level
2. Output indicator (Green)
Output signal level high enough for broadcast
3. LNK/ACT indicator (Green)
Being network-connected
Transmitting or receiving data
4. Busy indicator (Green)
Writing data, updating firmware, etc.
Broadcasts rejected due to priority
control on for s then off
5. Status indicator (Green)
Broadcasting
6. Error indicator (Yellow)
ailures or other system errors detected
ommunications error on for s then off
7. Run indicator (Green)
irm are malfunction
irm are normal operation
[Normal indicator status]
INPUT OUTPUT
(2)
ACT
(3)
BUSY
(4)
STATUS
(5)
ERROR
(6)
RUN
(7)
Description
Starting up
(for 30 seconds)
or or
or or
Continues for 30 seconds after the
unit is turned on.
If this status remains unchanged over
30 seconds, this shows unit failure.
Contact your TOA dealer.
No audio signals input
and output
or
Normal condition when broadcast is
not performed.
Audio signals input
and output
or
(Rapidly)
Normal condition when broadcast is
performed.
When rejected due to
priority control
to
A lower-priority broadcast made while
another broadcast is in progress is not
allowed to go through.
pdating firm are
Writing data
or
or
Automatically changes to the "Starting
up status above hen the firm are
update or data write ends.
Note
Never restart nor turn off the unit in
this condition, as doing so may cause
the unit to fail.
Indicator
s
status
on for s
then off)
to
or