28
14.2. Saving Settings & Changes
When all settings or changes are completed, save their contents.
Step 1. Click on the SAVE button.
The dialog box, "Changed contents enabled after restart." is displayed.
Step 2. Click on the OK button.
Note
The set or changed contents on this screen will not be in effect until the unit has restarted. To restart the unit,
click on the REBOOT button on the Maintenance screen. (See
"Restarting the Unit" on p. 36
[Broadcast switchover performed by broadcast priority settings]
Shown below are examples with the signal mode (
) set to Edge.
Higher priority input
Higher priority input
Control input
Broadcasting state
On
Off
Example of higher priority broadcast being input later
Lower priority input
On
Off
Lower priority input
Lower priority input
Higher priority input
Broadcasting state
On
Off
Example of lower priority broadcast being input later
Lower priority input
On
Off
Lower priority input
Input 1*
Broadcasting state
On
Off
Example of same priority broadcast being input later
Input 2*
On
Off
When a broadcast of the same priority is in progress, the latter-initiated
broadcast is not started.
Lower priority broadcasts initiated while a higher priority broadcast is in
progress are not started.
Last input broadcast
* Both are the same priority.
Higher priority input
Control input
Control input
Higher priority input
Lower priority input
First input broadcast
Last input broadcast
Lower priority broadcast is stopped by broadcast of higher priority.
Higher priority input
First input broadcast
