Toa A-9060DH, Инструкция по установке и эксплуатации

Страница: 42 / 136

42
13.4.2. Input setting items
Use the Parameter setting knob for each parameter selection.
I N 1 – _ _ _ _ _ _ _
(A1) Input channel name setting
The flashing portion is the cursor position for entering channel name characters.
Select a character from the alphanumeric character list by rotating the Parameter setting knob, then move the
cursor with the Right shift key.
Entering a new name overwrites the existing name, if there is.
To delete the character, select [ _ ] (under-bar) with the Parameter setting knob. Space cannot be entered.
Up to 7 characters can be used to set the name.
Even when an input channel name has been set, some setting screens display the channel number, not the
set name.
I N 1 – V O X – O F F
(A4) VOX ON/OFF setting (only in the normal matrix operation, when the D-001T is used)
Set the voice operated exchange (VOX) to ON or OFF.
• ON: Activates the set Event only when the audio signals are input to the module.
• OFF: The VOX function does not work.
(A2) Input sensitivity setting
(when the D-001T is used or when the AN-001T is used and ANC operation is set to ACTIVE)
I N 1 – S E N S I T I V I T Y – 1 0
Select the input sensitivity from the following 9 levels depending on the input sources:
Note
Setting the input sensitivity for the AN-001T's input channel automatically determines the reference level
which is a starting point for detecting the change in ambient noise level. The reference level can be fine
adjusted in Adjustment mode.
(p. 67, 72-D14)
7 characters (default: IN1 – 8) Setting Range
–60, –54, –48, –42, –36, –30, –24, –18, –10 dB (default) Setting Range
(A3) Phantom power ON/OFF setting
(when the D-001T is used or when the AN-001T is used and ANC operation is set to ACTIVE)
I N 1 – P H A N T O M – O F F
Set the Phantom power to ON or OFF.
• ON: Supplies the phantom power.
• OFF: Does not supply the phantom power.
ON, OFF (default) Setting Range
ON, OFF (default) Setting Range