TMB ProShell Скачать руководство пользователя страница 1

Страница: 1 / 2

ASSEMBLY INSTRUCTIONS

Insert RJ45 and cable into ProShell housing by

“rolling”, bottom first, over the small hump until RJ45

“snaps” completely into position. A distinct snap

must be felt to ensure proper alignment.

Prior to inserting cable into ProShell
housing, bend the cable to simulate the

shape of the internal strain relief mold of the

housing.

If installing optional protective cap, place

tether loop on tether post (bottom screw

standoff).

Lay non-logo side of ProShell housing (i.e.

side of housing without “ProShell” logo) on

hard surface with internal section facing up.

Using a small screwdriver, gently pry up the

RJ45 latch-tab 45-50 degrees. (Standard

procedure with RJ45s, as the tab may

compress during assembly.) Caution: Do not

lift too high and risk breaking the tab.

Содержание ProShell

Страница 1: ...mulate the shape of the internal strain relief mold of the housing If installing optional protective cap place tether loop on tether post bottom screw standoff Lay non logo side of ProShell housing i...

Страница 2: ...ar screws first then the front screw near the latch Do not overtighten especially the front screw Roll the logo side of the ProShell housing onto the housing cable thumb lock assembly Bottom section o...