Magnetic Inductor Installation
Silverado/Sierra-2019
B
A
C
Induction part C
Induction part C
Wire Harness Magnetic Inductor
B-pillar on the
right side (open
B
right side (open
the B-pillar
panel)
I
t th d
i
l i
Tighten the nut connecting
Remove the adhesive tape at
the back of C and stick one
A
Brown signal wire on
the right side
Earthing stud
D (Negative)
Insert the door signal wire
into A.
Tighten the nut connecting
B and ground terminal of
door pillars.
the back of C, and stick one
end on one side of the door
pillars.
Step 5:Open the B-pillar panel on the right side of the vehicle ,
expose the above part (as shown above), connect the brown
signal wire to terminal A of magnetic inductor, loosen the
hi
d D
f k
i l B
h
hi
Stick the other end to
the other side of
vehicle door pillars.
Stick the magnets to the inner side of the vehicle
door and keep their positions corresponding to C.
earthing stud D ,connect fork type terminal B to the earthing
stud , and then tighten the earthing stud. Stick the induction part
C to the both side of B-pillar, stick the magnet on the inside of
vehicle door which is corresponding with induction part. The
i
f hi
i
l i
d i h
i d
i
Magnet
Magnet
16
connection of white signal wire and wire harness induction on
the left side are same with the installation of the right side.
Instruction: The magnet position after closing the door is shown as above picture.
www.tmax.biz
