172-65128MA-11 (FS3/FS5/FS5H + BD2) 10 Mar 2017
5
Specifications
Install properly and DO NOT use this product outside the recommended
operating pressure, temperature and other specification ranges.
Improper use may result in such hazards as damage to the product or
malfunctions which may lead to serious accidents. Local regulations
may restrict the use of this product to below the conditions quoted.
CAUTION
DO NOT use this product in excess of the maximum operating pressure
differential; such use could make discharge impossible (blocked).
CAUTION
Use only under conditions in which no freeze-up will occur. Freezing
may damage the product, leading to fluid discharge, which may cause
burns or other injury.
CAUTION
The pressure and temperature values displayed on the nameplate of the
connector body are the values for the connector body itself and not for
the entire trap. Improper use may result in such hazards as damage to
the product or malfunctions that may lead to serious accidents.
CAUTION
Refer to the product nameplates on the trap unit AND on the connector body for
detailed specifications.
The specifications displayed on each nameplate apply only to the unit on which it is
mounted. When a trap unit is installed on a connector unit and the PMA/TMA and/or
PMO/TMO values displayed on the two nameplates differ, the specifications for the
assembled product are restricted to the lower values.
Trap Unit
*Maximum
allowable
pressure (PMA)
and maximum
allowable
temperature
(TMA) are
PRESSURE
SHELL DESIGN
CONDITIONS,
NOT
OPERATING
CONDITIONS.
**Valve No. is
displayed for
products with
options. This
item is omitted
from the
nameplate
when there are
no options.
Maximum Allowable
Temperature (TMA)*
Maximum Allowable
Pressure*
Model
Valve No.
Maximum Operating
Temperature
Maximum Differential
Pressure
Production Lot No.
Connector Unit (mounted only on F46)
Model
Maximum Allowable
Temperature (TMA)*
Maximum Operating
Temperature (TMO)
Nominal Diameter
Maximum Allowable
Pressure*
Production Lot No.
Maximum Operating
Pressure
Compatibility
•
The FS3/FS5/FS5H QuickTrap series employs a
connector unit (F46) and is
not compatible with QuickTrap models using connector unit F46J.
•
Trap unit (S3/S5/S5H) is compatible with
Trap Stations (V1/V2/V1P/V2P
Series) and can be installed on those trap stations or connector unit (F32).
The connector unit name is embossed on the connector body.
