For further information visit www.tlc-direct.co.uk
Installation:
Fig. 2
Fig. 3
Switch off the power source before installation & maintenance
Warning!
58mm
Fig. 1
Connect Cables
Wire Slot
Fig. 4
Wire Slot
NOTE:
Cabinet lights are mounted in series. The 18 watt power supply can feed up to 6 Ultra Slim
Cabinet lights.
Accessories available (sold separately):
LTCL1W
- 2.2W Ultra Slim LED Cabinet Light 4000K
LTCLC05M
- 0.5m Linking Cable with Connectors
LTCLC1M
- 1m Linking Cable with Connectors
Fig. 5
RECESSED INSTALLATION:
1. Determine the position of your cabinet light(s) and trace a 58mm diameter circle on surface
material. Using a keyhole saw or 58mm drill bit - cut
(Fig. 1).
hole
2. Feed the
through the hole and
to the
cable. Screw
connectors
join them
12V supply
the cabinet
into surface using the two screws (supplied) (Fig. 2).
light
3. Connect
to power feed and snap the magnetic bezel to the cabinet light (Fig. 3).
12V supply cable
4. Turn ON power to test for correct operation.
SURFACE INSTALLATION:
1. Determine the position of your cabinet light(s) and position cabinet light surface mount ring.
2a. Clean the surface; use the 3M sticky pad (supplied) and paste it to the bottom of the cabinet
light. Place the light in the required position and press to stick.
2b. Screw surface mount ring onto surface (Fig. 4) at the required position.
3. Making sure that you insert feed cables through surface mount ring wire slot, position cabinet
light onto surface mount ring. Ring is held magnetically (Fig. 5).
3. Connect 12V supply cable to power feed and snap the magnetic bezel to the cabinet light (Fig.3).
4. Turn ON power to test for correct operation.
