This plug-in ON/OFF Module in a transceiver which is a Z-Wave enabled device
and is fully compatible with any Z-Wave enabled network. Z-Wave enabled devices
displaying the Z-Wave logo can also be used with it regardless of the manufacturer,
and ours can also be used in other manufacturer's Z-Wave enabled networks. Remote
on/off control of the connected load is possible with other manufacturer's Wireless
Controller. Each module is designed to act as a repeater. Repeaters will re-transmit
the RF signal to ensure that the signal is received by its intended destination by
routing the signal around obstacles and radio dead spots.
Adding to Z-Wave Network
In the front casing, there is an ON/OFF knob which is used to carry out inclusion,
exclusion or association. Put a Z-wave Wireless Controller into inclusion/exclusion
mode, press the knob on the Module to complete the inclusion/exclusion process.
On/off knob
LED indicator
Installation
1.Plug this ON/OFF Module into a wall outlet near the load to be controlled.
2.Plug the load in to the Module. Make sure the load to be controlled cannot exceed
2990/3500 watts.
3.Turn the knob or switch on the load to the ON position
TZ68
ON/OFF MODULE
