TJM Pro Series Single Air Compressor: Installation and User Manual
For product warranty please refer to our website www.tjm.com.au
File: F-17800
Page 8 of 19
10/12/2021
3.2
Compressor Mounting Configuration
The compressor can be mounted at 5 angles to suit the available space: vertical (as supplied), at 30°
from vertical, or horizontal. This adjustment can be made before or after installation in the vehicle.
o
Using a 4 mm hex key, remove the 6 x
M5 x 22 mm mounting screws and washers
between the compressor and base plate
(3 x front and 3 x rear).
o
Remove the compressor from the base plate
o
Remove 2 x M5 x 10 mm screws from the fan
cover on the desired mounting side and
fasten them into the threaded holes
previously used for the base plate.
o
Reposition the compressor, apply some
silicone grease between the rubber isolator
and compressor to assist assembly.
o
Fasten the M5 x 22 mm screws, for horizontal
installation the centre rubber isolators do not
take screws.
o
Ensure the connecting plate and washers are
fitted between the screw and rubber isolator.
M5 x 22
