TJM Pro Series Single Air Compressor: Installation and User Manual
For product warranty please refer to our website www.tjm.com.au
File: F-17800
Page 14 of 19
10/12/2021
5.0
Post- Installation Examination
5.1
Leak Testing
Complete the following test with the vehicle in park and the engine off.
1.
Turn on the compressor on.
2.
The compressor air tank will fill to reach operating pressure.
3.
Wait for the Pressure Switch to turn off the compressor at 120 PSI.
4.
Monitor the time.
The compressor should not reactivate within a period of 10 minutes.
NOTE
: If the compressor refills in this time frame, there is a leak in the system. Complete the
following to determine and control the source of the leak.
5.
While the compressor is pressurised, spray soapy water on all the air fittings.
6.
Bubbles will appear at the source of the leak.
7.
De-pressurise the system.
8.
Re-tighten the leaking fitting/s and repeat leak test.
9.
If leaking continues, remove fittings, reapply sealant, and then re-assemble.
5.2
Post installation checklist
□
Compressor operational check completed.
□
Leak Test completed.
□
Compressor safely mounted using appropriate hardware.
□
Wiring Loom installed according to the TJM Diagram.
□
Air lines securely installed.
□
Switches hard-mounted to dash and out of reach of accidental activation.
□
Switches function and illuminate correctly.
Checked By:
Date:
