TJM Vehicle Mount Compressor Installation and User Manual
For product warranty please refer to our website www.tjm.com.au
File: F-17800.docx
Page 11 of 12
29/05/2019
Safety Relief Valve
o
The safety relief valve can be manually actuated
by pulling on the ring at the top of the valve.
o
Valve may be hot
–
use gloves while operating
valve.
o
DO NOT
operate the compressor without the
relieve valve installed.
7.0
Maintenance
Always ensure that the pressure in the compressor has been discharged before commencing.
7.1
Routine Maintenance
o
Periodically inspect and replace the air filter. Blocked air filters significantly reduce compressor
performance. Never run the compressor without a filter
–
this will reduce the life of the
compressor.
o
Periodically check fittings and airlines for leaks.
o
Periodically inspect mount bolts to ensure that they remain tight.
o
Periodically check the safety relief valve
–
ensure air is released when the manual override is pulled.
Note: The compressor does not use oil lubrication
–
there is no requirement to check / fill oil.
7.2
Replacement Parts
The major components of the compressor are designed to be maintenance-free for the life of the unit.
The following parts are available for servicing requirements:
o
013COMPVFILTER01 - Filter housing and element combined kit
o
013COMPVFILTER02 - Filter housing kit to replace housing only
o
013COMPVFILTER03 - Filter element kit
o
013COMPVACTSWITCH - Replacement activation switch kit
o
013COMPVMOUNTKIT
–
Replacement rubber isolator and bolt kit
o
013COMPVSRV155-18N
–
Safety relieve valve 155 PSI, male
⅛” NPT
o
013COMPVPS120-90
–
Pressure switch OFF 120 PSI / ON 90 PSI
