www.tivolilighting.com tel: 714-957-6101 fax: 714-427-3458
RGBW TRACE™ Horizontal Installation Instructions
7101009
Page 1 of 8
Copyright © 2020 Tivoli 06.23.20
Please verify the contents of the packages!
Please read instructions entirely before starting
installation
Be sure power is turned off before installing the system
Call Tivoli, LLC tech support with questions
Caution:
TRACE™ RGBW is designed to work with listed Class 2
24V DC transformers only. Use of any other power source will
cause damage, shorten the life of the fixture and will void the
warranty.
Consult
any and all applicable local and national codes for
installation.
Do not
conceal or extend exposed conductors through a building
wall as per local electrical code.
Warning:
With any luminaire for any application, basic safety
precautions should always be followed to reduce the risk of fire,
electric shock and personal injuries. This lighting system should be
installed by a certified professional.
TRACE™ is an indoor/outdoor low voltage lighting system
used primarily for direct or indirect lighting designs.
Profiles:
13/16”
15/32”
11/16”
13/16”
3/4”
5/8”
7/8”
11/16”
TRACE™ Horizontal
IP67
R
X
Trace™ Horizontal
Do not allow to twist or bend in the wrong direction.
WARNINGS
Keep Trace™ from twisting or bending in the wrong direction.
Two person installation.
WARNING!
Risk of product damage.
Longer runs of Trace™ lighting strands must be installed by at least
two people.
IMPORTANT!
The Trace™ luminaire must not be allowed to bend or
hang down. That way, the bending limit will not be inadvertently
exceeded, resulting in product damage.
TRACE™ RGBW MAY BE EASILY DAMAGED!
The reliability of
the product can only be ensured if these warnings and cautions
are complied with faithfully. Keep these instructions for future
maintenance work.
Warning!
Risk of product damage.
Trace™ RGBW Horizontal must not be bent at less than 2.0” diameter or damage will result. Do not allow Trace™ to twist or bend in the wrong
direction.
WARNING!
Risk of Damage.
Insert Trace™ RGBW Horizontal into
channel evenly and gradually
to keep twisting and
bending to a minimum.
Bending
Diameter
2.0”
