Overture DH - Short Base Plate
Fixing and Operating Instructions
Failure to adhere to these instructions invalidates your Titon Product Guarantee.
Paint or corrosion not covered by Guarantee.
1. Rout / drill door.
2. Cut screws (M5) and spindles (8mm Square) to length if
necessary.
3. Place spindles in position
4. Place both handles into position and insert and tighten
fixing screws, leaving loose.
5.
Fit Euro cylinder and tighten handle fixing screws, do not
over tighten.
Cleaning
Door handles should only be cleaned using warm soapy water
and a soft cloth.
Do not clean any part with solvents or abrasive substances.
21.5
92
122
R9.5
16
Ø12
Ø10.5
Ø10.5
Routing / Drilling Detail
Supplied with:
1 shafts 108mm
1 shaft 95mm
2 screws M5 85mm long
2 screws M5 75mm long
TN8100 & TN8104
(Lever/Lever)
Supplied with:
1 shafts 108mm
2 screws M5 85mm long
2 screws M5 75mm long
TN8101 & TN 8105
(Lever/Pad)
Fixing Instructions
Diagram
BM484 Iss01 © 2014
Page 1 of 3