Titgemeyer TIOS EL18, Руководство по эксплуатации

Страница: 14 / 28

14
Phone: +49 (0)5 41/58 22-0 Fax: +49 (0)5 41/58 22-491 email: fasteners@titgemeyer.com
L
Tb1547GB(1113)1
TIOS
®
EL18 Battery-operated Lockbolt Tool
Operating instructions
Preparing and fitting the rivet tool
Initial setup
Mandrel collector
Charging battery
Description of LED status
on the charger
1. Read the operating instructions and keep in a safe place.
2. Perform a visual inspection of the devices to check for defective or loose parts
(damage in transit).
3. Plug the charger into the mains.
4. Insert the battery into the charger (check the display!).
5. Charge the battery (approx. 60 min).
6. Attach the spent mandrel collector. To do this, rotate the collector about a quarter turn and
pull backwards to detach. Fully empty the collector and then reattach by following the above
steps in reverse.
7. Insert the battery into the rivet tool until you hear an audible “click”.
(To remove the battery, press the catch downwards and pull the battery forwards).
8. Press the start trigger.
9. The rivet tool is now ready for use.
• Note:
A magnetic contact switch is installed on the mandrel collector. If the collector has not been
fitted or if the contact is not closed, the tool will not operate.
Left LED Right LED
Battery charged
Defective battery
Battery too hot
or too cold
Charging
battery Mains
Defective
charger