TA 250 / TA 450
(0001)
50
/
112
8.3. Seal quality
To make the best seal perform some test strapping
operations and thus set the best
welding time and tensioning force.
The values to be set depend on strap dimensions and strap quality; they may vary. For the
reasons mentioned above TITAN cannot define generally applicable parameters.
Seal quality is very important; it can be subjected to a visual inspection.
Best seal
Bad seal
Welding time too short
Bad seal
Welding time too long
8.4. Strap mismatch - correction
Due to the use of differently thick plastic strap a strap mismatch of upper and lower straps
may occur.
If the
mismatch
points
out
to the left
(figure 8.4.1)
,
slightly turn
the
outer threaded pin to the left
and
the
inner to the right
.
If the
mismatch
points out
to the right,
i.e. to the inner
side of the tool (figure 8.4.2)
, slightly turn
the
outer
threaded pin to the left
and the
inner to the right
.
Repeat both operations until a uniform seal (figure
8.4.3) has been achieved.
8.4.1
8.4.2
8.4.3
H TA 250 / 450 EU 38/15
Содержание TA 250
