TA 250 / TA 450
(0001)
39
/
112
3. Safety regulations
Failure to comply with the following safety instructions, in addition to errors in handling the
device, can result in serious injuries.
Be informed!
Read
the
operating
manual
carefully before using the device.
Caution: Danger of crushing!
Do not insert fingers into the pulley
area.
Protect yourself!
Always wear eye, face and hand
protection (cut-resistance gloves)
when working.
Caution:
Strap only objects tob e packed!
Make sure that no hands or other
body parts are between the strap
and the goods to be packaged.
Attention: Strap can break!
The
strap
can
break
during
tightening! Do not stand in the path
of the strap. Make sure that no one
else is in the working area.
Attention: Strap flies outward!
When cutting the strap, hold the top
part firmly and stand to the side.
Use always a proper safety strap
cutter.
Attention:
The lower part of the
strap will fly outward.
TITAN recommends the use of
edge protectors on goods with
sharp corners to protect the strap
from damage.
Never move goods with bad
quality seals.
Check the quality of
every seal in order to avoid severe
injury.
Use only original TITAN
replacement parts!
The use of other than original
TITAN replacement parts will void
the warranty and all liability.
The use of straps other than
recommended can result in broken
straps during the tightening process
and insufficient strapping.
Use only
corresponding quality products
from TITAN!
This tool may be operated only by
personnel who have been trained
accordingly. Please consult your
TITAN packaging consultant
if
you have any questions about this.
Workplace!
Always
maintain
an
orderly
workplace. A disorderly workplace
can
cause
accidents.
When
operating the crimper, make sure
that you’re in a well-braced position
in order to maintain optimum
balance and prevent the risk of
falling. Never operate the tool in an
awkward working position!
Maintenance!
In order to operate safely, the tool
must be properly maintained. Check
the condition of your tool regularly
for defects or worn parts. Never use
a tool that has defects or worn
parts. Modifications to the tool are
strictly prohibited. Failure to comply
with this regulation can result in
serious injury.
H TA 250 / 450 EU 09/15
Содержание TA 250
