Titan HD4P-12000, Инструкция по установке, эксплуатации и обслуживанию

Страница: 23 / 44

19
LOWERING THE LIFT
1. Clear all obstacles from under lift and vehicle, and ensure only lift operator is in the lift
area.
2. Stay clear of lift and raise the lift off the safety locks.
3. Pull safety lock release handle and press the lowering handle to begin descent.
4. Ensure lift is fully lowered, and remove tire stop plates prior to unloading the vehicle.
5. Make sure to install the ramps.
6. Having another person guide you, carefully unload the lift by driving off of the lift
runways.
It is important to keep the lift clean, dry, and well maintained by establishing a periodic
preventive maintenance program to ensure trouble-free operation and long service life.
WARNING: PAY ATTENTION TO THE LOWERING SPEED OF ALL FOUR
CORNERS. MAKE SURE THEY ARE MOVING DOWN AT THE SAME SPEED. STOP
LOWERING THE LIFT BY RELEASING THE LOWERING LEVER ON THE POWER UNIT
AND MOVING THE LOCK LEVER TO THE LOCK POSITION IF ANY CORNER STOPS
MOVING OR IS SLOWER IN DESCENT. ALWAYS LOCK THE LIFT BEFORE GOING
UNDER THE VEHICLE. NEVER ALLOW ANYONE TO GO UNDER THE LIFT WHEN
RAISING OR LOWERING.
WARNING: DO NOT GO UNDER VEHICLE UNDER ANY CIRCUMSTANCES
WHILE VEHICLE IS BEING LIFTED OR LOWERED.
WARNING: DO NOT GO UNDER VEHICLE UNDER ANY CIRCUMSTANCES
WHILE VEHICLE IS BEING LIFTED OR LOWERED.
WARNING: DISCONECT THE POWER BEFORE SERVICING THE LIFT.
IMPORTANT: IT IS NORMAL FOR AN EMPTY LIFT TO LOWER SLOWLY - IT
MAY BE NECESSARY TO ADD WEIGHT.
IMPORTANT: THE MAINTENANCE INTERVALS INDICATED BELOW APPLY TO
AVERAGE WORKSHOP USE. THE LIFT SHOULD BE INSPECTED MORE FREQUENTLY
FOR SEVERE USE APPLICATIONS.
7-MAINTENANCE
7.1 MAINTENANCE SCHEDULE