Titan HD4P-12000, Инструкция по установке, эксплуатации и обслуживанию

Страница: 13 / 44

9
COLUMN & CROSSBEAM INSTALLATION
2) Install the latch bar (safety lock ladders) into columns with threaded stud end exposed
through the hole in top plate. DO NOT tighten the top nut and DO NOT secure the
bottom of latch bar at this time. (See Fig. A)
Fig. A
Latch Bar
Bolt and Nut
Threaded Stud
Nut
3) Place a chalk line on the floor according to the floor plan layout. Stand the columns
at their respective locations. DO NOT BOLT columns down at this time. Use caution to
prevent the columns from falling over. Place one crossbeam next to their appropriate
columns with cable sheave window positioned inward. Hold the threaded stud and
raise the Latch Bar to clear space for assembling crossbeams into columns (making
sure the plastic slide blocks are still in position,) then drop down the latch bar through
the slide block guide slots on crossbeams until the ladders come to rest on the base
plates. Tighten the top nut on top plate and secure the bottom latch bar with bolt, nut
and washer. Complete the same process for the other crossbeam.