Titan Lifts HD2P-13KCL, Инструкция по установке, эксплуатации и обслуживанию

Страница: 8 / 40

4
The following is a 2-Column hydraulic, leaf chain driven lift.
The model numbers covered in this manual are designated below:
HD2P-13KCL: 2-Column Overhead Beam Lift type, 13,000 lb Capacity, Symmetric
Swing Arm set up.
This lift is a 13,000 lb capacity, 2-Post Lift. The safety latch system is very similar to an
extension ladder. The safety latch is in contact with the rack as the lift ascends and drops
into place as the lift rises. Safety latch engages in rack in 3” increments at about 16” from the
ground. The latch must be manually disengaged for the lift to descend. The latch is released
by raising the latch rack using the hydraulic drive system and pulling the release handle. If
the user lets go of the manual release handle, the safety latch will re-engage on the next lock
latch it encounters. Heavy bearings and heavy-duty leaf chains are used throughout the lift.
The work is done with the heavy-duty chain connected to a 4” cylinder, driven by a hydraulic
pump capable of providing 3,000 psi.
Please read the Safety Procedures and operation instructions in this manual before
operating the lift. Proper installation is very important. To minimize the chance of making an
error in installation, please read this manual thoroughly before beginning installation. Check
with building owner and/or architect’s building plans when applicable. The lift should be
located on a level floor with 6” 3000 psi concrete sufficiently cured, for at least 30 days.
This is a vehicle lift installation / operation manual and no attempt is made or implied herein
to instruct the user in lifting methods particular to an individual application. Rather, the
contents of this manual are intended as a basis for operation and maintenance of the unit
as it stands alone or as it is intended and anticipated to be used in conjunction with other
equipment.
Proper application of the equipment described herein is limited to the parameters detailed
in the specifications and the uses set forth in the descriptive passages. Any other proposed
application of this equipment should be documented and submitted in writing to the factory
for examination. The user assumes full responsibility for any equipment damage, personal
injury, or alteration of the equipment described in this manual or any subsequent damages.
2-DESCRIPTION