TIPTEL 40 VoIP, Инструкция по установке и эксплуатации

Страница: 28 / 40

Operation
28
Operation
Configuring the terminals
Incoming calls
In order to accept incoming calls it is necessary to configure the telephone system or
ISDN telephone that is connected.
The procedure for programming is similar to setting up an ISDN multi-point
connection.
The tiptel 40 VoIP sends all recognized calls with the registered call number to the
connected device.
For this, all call numbers stored in the SIP accounts are registered in the telephone
system as "Exchange numbers". The calls are then distributed according to the
internal assignment in the telephone system as if it were an ISDN multi-point
connection.
If you are using ISDN telephones, enter the SIP account call numbers into the
telephone as "MSNs".
Note: Due to the large variety of terminals found on the market we cannot
provide any information on operation. In this case we refer you to the
operating instructions of the particular terminal.
Outgoing calls
To make outgoing calls with the tiptel 40 VoIP it is also necessary to configure the
device.
The assignment of the SIP account that is to be used depends on the outgoing call
number of the telephone system or ISDN telephone that was sent.
Set up your telephone system for outgoing calls so that the call number of the
desired SIP account is sent to the tiptel 40 VoIP.