Timotion MA1_DC, Руководство пользователя

Страница: 18 / 24

User Manual-MA1_DC Version
Version B July 2020
18 of 24 18
2.3.7 Two limit switches to send signal and a single Hall sensor
The actuator is equipped with two limit switches to send signal of the motor when the actuator moves to the
end of each stroke, and with a single Hall sensor sending position signal output.
Wire AWG Description Spec
Red
(Power)
14 Connect to Vm+ to extend the actuator
Connect to Vm- to retract the actuator 24V version: Input voltage 18~32 V DC
12V version: Input voltage 9~16 V DC
Black
(Power)
14 Connect to Vm- to extend the actuator
Connect to Vm+ to retract the actuator
Red
(Hall)
20 +5V DC input signal power for Hall
sensor board.
Hall sensor output signal type is square
wave with Hi voltage 5V and Low voltage 0V,
and with the output current of 0.1A (please
refer to the approval drawing for the
resolution and details).
Hall sensor circuit is independent to motor
power circuit.
White
(Hall)
20 Output Hall sensor signal during the
actuator moves.
Black
(Hall)
20 Hall sensor signal ground.
Yellow
(Signal)
18 Connect to common pin (C.) The signal is potential free and independent
from the motor power circuit.
The signal is short circuit when the actuator
moves to the position where the middle limit
switch is triggered.
Connect the middle limit switch signal with
max 32V, <1A.
Green
(Signal)
18 Connect to normal closed pin (N.C.)
Red
(Signal)
18 Connect to normal closed pin (N.C.)
Black
(Signal)
18 Connect to common pin (C.)
Red (Hall)
White (Hall)
Black (Hall)
Red (Power)
Black (Power)
Yellow (Signal)
Green (Signal)
Red (Signal)
Black (Signal)