Timespace X300 Mark 2, Инструкция по эксплуатации

Страница: 38 / 185

X300 Instruction Manual Chapter 3 - User Guide – X300 Menu System
27
3.1.4 SD Recording
The X300 supports a single SD card for two functions;
SD CARD RECORDING - The X300 can be configured to record up to 25 images per second to the SD
card in addition to the primary images per second being recorded to the cartridge. All additional data
for example Audio and GPS are also included within the SD recorded files.
FILE COPY - Files that are recorded on the X300 cartridge can be selected and copied to the SD card
for review on a PC.
STATUS – shows the current Status of the SD card i.e. PRESENT, NOT PRESENT or RECORDING TO SD.
RECORDING ENABLE lists the available modes of recording for the SD card.

OFF – SD recording is OFF, no SD recording.

ON – SD recording onto SD card all the time.

IF NORMAL REC – SD recording only occurs if the X300 is recording in Normal mode.

IF TIMER REC – SD recording only occurs if the X300 is recording in Timer mode.

IF ALARM REC – SD recording only occurs if the X300 is recording in Alarm mode.
LOCK OVERRIDE can be used to override the physical lock status of the SD card. For example if an SD
card is inserted with the lock enabled, this usually prevents any data being written, however the
X300 can override this.
HDD FAIL SD REC – sets the number of seconds for which the SD card will record once a Hard Disk
write fault has been detected (before the X300 reboots in order to re-try the HDD).