Time Electronics
User Manual
7085A Temperature Distribution and 10 Channel Scanner Module
v1.1
7085A Temperature Distribution and 10 Channel Scanner Module
Page 5 of 21
1.2
Specifications
Requirements
The 7085A interfaces with 7051, 8060, 8051 and 5065B modules. For
automation EasyCal software is required on a control centre module or
separate PC.
Thermocouple Input
Connections
8 x inputs, connections via standard & miniature TC type, or 4 mm
shrouded sockets
Reference RTD Input
Connection
1 x RTD input, connections via 3 wire RTD type, bare wire screw
terminals, or 4 pin multiway connector
Reference
Thermocouple
A reference thermocouple can be used by connecting to input #8 on the
module
Internal Connections
Integral to the CalBench console for communication with compatible
modules
Maximum AC Voltage
125 V rms or 175 V peak, 100 kHz, 1 A switched, 62.5 VA (resistive load)
Maximum DC Voltage
110 V, 1 A switched, 30 VA (resistive load)
Actuation Time
5 ms maximum on/off
Contact Potential
< ±500 nV typical per contact, 1
μV max / <
±500 nV typical per contact
pair, 1
μV max
Isolation between
any two terminals
> 10 Gohm, < 75 pF
EasyCal Compatible
Dry Block Calibrators
For full automation a TE dry block calibrator can be driven by EasyCal
software. Models supported include: 8070, 8071, 8072, 7860, 7862,
7870, 7872, 7880, 7882.
See separate data sheets for information and specifications
Module Width
250 mm (primary or secondary console fitting)
