STEP 2:
Install the two wheels. See FIGURE 5.
1. Raise the reservoir tank assembly off the ground on some blocks before mounting. Remove the plastic shipping
caps from the wheels and position the wheels onto the wheel axels.
2. Screw the castle nuts onto the axels and tighten with an adjustable wrench to seat the bearings. Then back the
castle nuts off one half turn and snug them up to the bearings by hand, so they line up with the hole in the axel.
3. Insert the split pin into the slot of castle nut and the hole in the axel, then bend the ends of the pin with needle nose
pliers
keeping it close to the castle nut so the dust cap fits over it
.
4. Tap the dust caps onto the wheel using a soft faced hammer.
(FIGURE
5)
REF.
NO.
4
5
5-1
5-2
5-3
DECSRIPTION
QTY.
Off
– Road tyre / Wheel
2
Hardware Kit #2, including:
1
Castle nut / 1-14
2
Split pin /
Ø
4 x 50
2
Dust cap
2
Page 14
