Timberk WHE 12, Инструкция по эксплуатации

Страница: 8 / 48

www.timberk.com • electrical instant water heater
8
6. PACKAGE CONTENTS
7. INSTALLATION OF WATER HEATER
1. Water heater – 1 pc.
2. Mounting fittings – 1 pc.
3. Operational Manual – 1 pc.
4. Warranty card – 1 pc.
5. Packing – 1 pc.
Location
1. Water heater can be installed in any place provided that the indoor
temperature is not lower than 0°С.
2. Water heater is installed at the flat wall surface in strict parallel to the
floor with outlet nozzles in downward direction; it shall be installed at a place
where water and splashes cannot get onto its housing.
3. When water heater location is being defined, free access to it shall be
assured, not less than 0.3 m from the top, bottom and sides. It will provide for
the maximum convenient servicing and regulation of water heater if required.
4. Water heater shall be installed in such a way that a distance from the
bottom part of the device to the floor does not exceed 1.6 m.
Mounting of Water Heater
WATERMASTER I Series. Water Heater Models: WHE 3.5 XTR H1, WHE
4.5 XTR Н1, WHE 5.5 XTR H1
As shown in Figure 7, identify the points for openings and drill 2 openings
of the corresponding depth in the wall, insert dowels, screw up the screws,
and make sure that there is a certain distance between the screw head and
the wall, then hang the water heater on the screws (see Fig.8) and check
the reliability of fixing.
NOTE:
Water heater installation at the place of its operation
and electric power connections shall be performed
by the specialized organization, a representative
of the manufacturer’s maintenance service or
experts licensed for execution of electric equipment
assembling with safety regulations observed.
In the event of violation of water heater operation
manual, water heater is not subject to warranty
servicing, and the manufacturer cannot be held liable.
Fig. 7
Fig. 8