Timberk WHE 12, Инструкция по эксплуатации

Страница: 15 / 48

www.timberk.com • electrical instant water heater
15
Water heater operation
1. During the first water heater start-up or after long-term non-use, fill the
device with water by opening the cut-off tap at cold water supply line,
and make sure that there is a steady cold water flow at water outlet at the
consumption point, after that switch on the device power supply, indicating
lamp 1 at the control panel (see Fig.15) starts blinking.
2. To switch on the device, press « » button at the control panel, power
supply indicator 1 (see Fig.15) will be constantly lit up.
3. Water temperature can be set 35°С to +60°С range with the help
of « » button (value increase) and « » (value decrease). If water heater
does not heat up to the temperature set, water flow shall be reduced with the
help of the tap at the inlet nozzle.
4. Water flow is controlled by the tap at water inlet to or outlet from water
heater. When there is water flow, and water pressure is not less than 0.1
MPa, heating is switched on automatically, and indicating lamp 2 located at
the control panel lights up (see Fig.15).
5. After heating is switched on, you need to wait for 10-20 seconds to let
temperature of heated water stabilize.
6. Incoming water is heated up inside the heating flask when it is flowing
through the heating element. Water temperature in the water supply main
may vary depending on a season from +3°С to +20°С, so, in winter water
flow shall be less than in summer to assure the optimum water temperature.
To switch off the water heater, simply close water flow at the inlet to or
outlet from the device; electronic flow sensor automatically opens the circuit
of power supply to heating element, and indicating lamp 2 located at the
control panel goes down (see Fig.15), and power supply indicator 1 starts
blinking. For the subsequent switching on of heating it is enough to reopen
the water supplying or water draining tap.
IMPORTANT!
If these activities have not resulted in any positive
outcome or temperature switch trips out repeatedly
within a short period of time, switch off power
supply to water heater, close water supply to water
heater and address the Authorized Timberk Service
Center located at your region to receive any advice
or maintenance. For the address of the Authorized
Service Center, please, consult with the seller or visit
our web-site at www.timberk.com.
7. Temperature switch stops the power supply to heating element in the
event of water overheating inside water heater. If water heater is connected
to the electric main, and water heating is switched on, but water is not
heated up, it means that the temperature switch has tripped out or was
WATERMASTER III Series. Water Heater Models: WHE 12.0 XTL C1, WHE
18.0 XTL C1, WHE 21.0 XTL C1, WHE 24.0 XTL С1.
Control Panel
IMPORTANT!
Do not switch on the water heater if there are grounds
to suspect that water inside it has frozen.
1. Power supply indicator
Blinks if the device is power supplied,
and lights up when device is switched
on.
2. Heating indicator
Lights up when water is heated.
3. LED-display
The display shows the current
water temperature value, and when
temperature is set – desired water
temperature value.
4. « » button
Is used to switch on and switch off
the device.
5. « » button
Is used to reduce water temperature
value.
6. « » button
Is used to increase water temperature
value.
Fig. 15