ASSEMBLY SCHEMA
Table Moon/Moon-S
Contents
a)
c)
e)
b)
d)
f)
g)
1 pc. Tabletop with Cross
1 pc Metal Tube
1 pc Washer
1 pc Moon Table Leg
1 pc Weight Mounted Driftbolt
1 pc Fibered Nut
1 pc Nuts
MOON TABLETOP 60Ø
MOON-S TABLETOP 70Ø
MOON TABLETOP 70x70cm
Please be sure not the miss any screw holes and fasten
all screws equally and tightly. Otherwise, you may face
breakage or cracking during the time of usage.
4
Tighten the nut
with a 17 wrench
or ratchet.
2
3
Place the driftbolt
(d) to the center
hole of the
cross part of the
tabletop (a), then
rotate until its fully
inside, then fix it
with the nut (g)
Place the aluminum
tube (c) until it covers
the driftbolt with
balance weight (d).
Then place the table
leg (b) under the
aluminum tube, make
sure to fit the notch.
Then insert the washer
(e) and fibered nut (f).
The direction of
closure of the table
and the notch of the
leg must be in the
same direction
b
e
f
d
a
g
c
(Fixed)
1
Remove fibered nut (f) and washer (e) and one of the nuts (g)
from the driftbolt (d).
f e
g
V07072
02
1
