K-Box A6 User's Manual
English
2 / 44
tiko Energy Solutions AG
IM-0005-0001 Rev. 8
Safety Warnings and Working Instructions
Hazard Risk
Read the user manual before installing and operating this product!
Installation by person with electronical expertise and trained on this product
only!
Disconnect all power sources before carrying out any manipulation!
Always use appropriate protection equipment!
Danger! High voltage!
Never touch disconnected wires! Life hazard!
Only use for current/voltage as indicated on the device label! Doing otherwise
can cause device damage and may pose an electrical shock or fire hazard!
Not properly tightened screws can cause a high contact resistance, lead to
overheating and cause a fire hazard!
Not properly connecting the Neutral will damage the device and pose safety
risk!
External voltage risk! An external voltage source can be connected to the
K-Box relay terminals. Even if all the main counters are open/disconnected,
there could still be high voltage on the relay terminal clamps coming from an
auxiliary source (e.g. ripple control, UPS, generator, PV, emergency PSU). Be-
fore any handling verify that there is no voltage source wired to the K-Box.
Warnings
•
Read the installation instructions before you connect the system to its power source.
•
To prevent the system from overheating, do not operate it in an area that exceeds
the maximum admitted ambient temperature of 55 °C.
•
This product relies on the building’s installation for short
-circuit (over current) pro-
tection. Ensure that a fuse or circuit breaker no larger than 230 VAC, 65 A is used on
all current-carrying conductors.
•
The circuit breaker shall be in front, close to the device, easily reachable by the op-
erator, and it shall be marked as the disconnecting breaker for the device.
