TIGIEFFE Airo V Series, Руководство по эксплуатации и обслуживанию

Страница: 29 / 103

Use and Maintenance Manual - Series V8 E V10 E Page 29
5.1.2.
Platform positioning movements
To carry out all movements other than drive, use
proportional levers B , C , D.
To achieve the movement, it is necessary to carry out
the following operations in sequence:
a) Press and hold down “dead - man” pedal M or
pre ss and release “dead - man” button N located
on the platform; the green led ZA will light up
steady indicating its enabling;
b) In case of use within 10 seconds from the
green steady led lighting up, set the
proportional joystick control or the desired
switch in the direction shown by the serigraphy
on the control panel.
c) In case of use within 2 seconds from the green
steady led lighting up, set the proportional
joystick control or the desired switch in the
direction shown by the serigraphy on the
control panel.
Fig. 7
NOTE: before activating the proportional joystick control or the desired switch the dead-man pedal must be pressed.
Release the “dead - man” pedal and the manoeuvre will be immediately stopped.
The platform positioning controls can’t be used simultaneously. The turret orientation can be used at the same
time as the drive and steering controls in lowered platform conditions (telescopic column lowered, jib at a height
b10° and -70°).
5.1.2.1.
Telescopic column lifting/lowering
To lift/lower the pantograph (first boom), use the proportional lever
B .
Set the proportional lever B forward for lifting or backward for lowering.
5.1.2.2.
Jib lifting/lowering.
To lift/lower the JIB, use the proportional lever C .
Set the proportional lever C forward for lifting or backward for lowering.
5.1.2.3.
Turret orientation (rotation)
To carry out the turret orientation (rotation), use the proportional lever D.
Set the proportional lever D to the right in counter-clockwise rotation or to the left in clockwise rotation.
With platform lowered (telescopic column lowered, jib at a height between +10° and – 70°) simultaneous
steering-drive-turret orientation is possible to facilitate the machine positioning in narrow spaces.