TIGIEFFE AIRO R Series, Руководство по эксплуатации и обслуживанию

Страница: 67 / 114

Use and Maintenance Manual - R13 R17 Series Page 67
7.2.4. Hydraulic filter replacement
7.2.4.1. Suction filters
All models are equipped with a suction filters (see picture aside)
installed inside the tank at the base of the suction tubes, which
have to be cleaned or replaced at least every two years.
To replace the suction filters installed inside the tank (see figure):

Stop the machine by pressing the emergency stop button
of the ground control unit.

Unscrew the cover from the tank.

Extract the cover from the tank.
 Unscrew filter from the suction tube and replace.

To restore the initial condition, carry out the above-
mentioned operation in reverse order.
During these operations a quantity of oil may leak out. In this case
remove the oil by means of cloths or let the oil flow by placing a
suitable container under it.
Fig. 26
7.2.4.2. Return filter
The return filter directly flanged on the tank is equipped with a
visual clogging indicator. During normal operation, the visual
indicator is in the green zone. When the indicator is in the red zone,
the filtering cartridge is to be replaced.
However, the filtering cartridge should be replaced at least every
two years. To replace the filtering cartridge:
 Stop the machine by pressing the emergency stop button
on the ground control unit.

Remove the filter cover.

Remove the cartridge.

Fit the new cartridge paying attention to the correct
position of the retaining spring and place the cover again.
Fig. 27
During these operations a quantity of oil may leak out. In this case remove the oil by means of cloths or let the oil flow by placing
a suitable container under it.
IT IS FORBIDDEN to start the machine when the filter cover is missing or not properly tightened.
Replace the filters using only original accessories available at our Technical Support.
Do not re-use used oil and do not leave it in the environment, but dispose of in compliance with local standards in force.
Once the filters have been replaced, check the hydraulic oil level in the tank.