Multi-function AV Distribution System
25
5.5 Copy and Load Control Settings
The system IR or RS232 configuration can be copied to a USB thumb drive and loaded
into additional systems or be saved as a backup.
Copy Control Setting
1)
Insert a 4GB or smaller FAT32 formatted thumb drive into the
CONFIG
port on
the control panel.
2)
Synchronously press
HDMI 2
and
OFF
buttons for three seconds on control
panel. As soon as release the buttons, they will light up while the copy is in
progress.
3)
Remove the thumb drive from the
CONFIG
port once all buttons go dark.
Load Control Setting
1)
Insert a 4GB or smaller FAT32 formatted thumb drive with saved configuration
settings into the
CONFIG
port on the control panel.
2)
Synchronously press
HDMI 1
and
ON
buttons for three seconds on control
panel, and then the buttons will go dark while import successfully.
3)
Remove the thumb drive from the
CONFIG
port once all buttons go dark.
4)
Enter the Command Tab via GUI, the loaded RS232 commands will be showed,
and then press
Save
to confirm them.
