Tiger Box1 Assembly Guide
System Restore: System Restore
24
5.
Plug the power cable in the module's socket and power on the appliance.
System Restore
Use the USB flash drive included in your Tiger Box1 appliance shipment to restore the
appliance to the factory default settings in case of system malfunction or failure.
Important:
All your settings (IP addresses, defragmentation preferences, password
for the web interface, etc.) will be lost after restoring the system to the default factory
settings.
Follow the instructions below or contact Tiger Technology support for assistance at:
[email protected]
To perform system restore:
1.
Shut down the appliance.
2.
Plug the USB flash drive in the USB port of the appliance and press the power
button to start it.
When the system restore finishes, the appliance automatically shuts down.
3.
Unplug the USB flash drive and press the power button of the appliance to start it.
4.
Wait several minutes until the appliance node shuts down again and then press the
power button to start it.
Note:
On appliances shipped before 20 December 2016, the system restarts
automatically instead of shutting down one last time before the appliance is ready.
To ensure that the system restore is finalized, wait between 5 and 10 minutes
before attempting to access it.
Initial Setup of the Appliance
Before you begin work with the product on a Tiger Box1 appliance, you need to
perform its initial setup. The initial setup includes the following procedures:
•
Configure the IP address of each network port of the appliance (see “Configure the
IP Addresses of the Appliance” on page 27).
•
Change the name of the appliance (see “Change the Name of The Appliance” on page
28).
•
Specify the time and date settings of the appliance (see “Specify The Time and Date
Settings of the Appliance” on page 28).
•
Set the environment in which Tiger Box1 operates - workgroup or Active Directory
domain (see “Select The Deployment Environment of Tiger Box1” on page 29).
Once you go through the initial setup, Tiger Box1 can operate normally without having
to change any of its settings. Later on you can change any of the settings that you have
specified during the initial setup from any computer that has access to Tiger Store’s
web interface.
You can perform the initial setup of the appliance in the web interface of your storage
server.
Access the Web Interface
Tiger Box1 appliances are shipped to you with preset IP address of the Public port
(172.16.100.100) and a preset address of the Admin port (1.2.3.4 or 1.21.32.1), if such
port is predefined by vendor.
