1.
Select the compatible
Steadicam camera
weight for GoPro®
housing used.
2.
Clean and
dry housing surface
before application.
Remove backing
from VELCRO®.
3.
Center weight left to right on
back door, align top edge of
weight with bottom of housing
latch (A), press weight onto
backdoor (B). After VELCRO®
sets for one hour the weight can
be removed. When re-installing the
weight, align the VELCRO® strips
and press together. An audible click
will signal a secure hold.
H1
H2
H3
A
B
VELCRO
VELCRO
V
VELCRO
VELCRO
®
VELCRO
®
V
V
W3
W2
W1
A.
For use with H1, H2,
and H3 housings install
(1) W1 and (2) W3
weights into outer
weight tube. Balance
the CURVE as required,
see original instructions.
B.
Holding the handle
with the CURVE horizon-
tal, release the arc. If the
camera side (A) falls
down add weight W3
into the outer weight
tube. If the arc side (B)
falls to vertical (<1 sec.)
remove W3 weight from
the outer weight tube. If
the arc side (B) falls
to vertical (
≥
1 sec.),
continue to next step.
C.
Re-balance the CURVE as required,
see original instructions.
Visit:
tiffen.com/manual/CURVE
to view the original instruction.
To find all the camera and
housing combinations visit:
tiffen.com/curve_compatibility
Visit:
tiffen.com/manual/SMOOTHEE
to view the original instruction.
To find all the camera and
housing combinations visit:
tiffen.com/smoothee_
compatibility
A.
When using the
SMOOTHEE, install
the camera on the
SMOOTHEE mount
and set front weight
by moving it up from
index mark (A) to
position (B). Balance
the SMOOTHEE as
required, see original
instructions.
B.
Holding the handle
with the SMOOTHEE
horizontal, release the
arc. If the camera side
(A) falls down, lower the
front weight. If the arc
side (B) falls to vertical
(<1 sec.), raise the front
weight. If the arc side (B)
falls to vertical (
≥
1 sec.),
continue to next step.
C.
Re-balance the SMOOTHEE as
required, see original instructions.
Set Up
For use with CURVE
For use with SMOOTHEE
A
B
A
B
A
B
