7
•
place the device in a dry place and away from sources of heat;
•
place the box-container;
•
place the probes so read the temperature correctly, avoid the direct or indirect contact with the flame:
T1 collector temperature probe
install on the solar panel collector.
T2 main boiler temperature probe
install in the low part of the boiler, close to the heat exchanger linked to the solar panels.
T3 main boiler temperature probe
install in the top part of the boiler possibly close to the water delivery point
T4 secondary boiler temperature probe
install according to the diagram of configuration, for more indications refer to relative paragraph.
•
make electrical wiring according to the numeration (fig. 2);
The wiring to power supply must be carried out only after the connection phase. The devices connected are
protect from fuse 3,15A.
TECHNICAL CHARACTERISTICS
See table 4. (Appendix pag. 8)
ATTENTION
-
Keep sensor and power cables separate. Use free-braided bipolar screened cable min. cross-section 1.5 mm²
and max. Length 25 m.
-
The appliance must be wired to the electric mains through a switch capable of disconnecting all poles in
compliance with the current safety standards and with a contact separation of at least 3 mm in all poles.
-
Installation and electrical wiring of this appliance must be made by qualified technicians and in compliance
with the current standards.
-
Before wiring the appliance be sure to turn the mains power off.
In the view of a constant development of their products, the manufacturer reserves the right for changing technical data and features without prior notice. The
consumer is guaranteed against any lack of conformity for 24 months from the time of delivery, according to the European Directive 1999/44/EC. The full text of
guarantee is available on request from the seller.
The company does not answer for which had damages to wrong wiring or improper use of the device.
APPENDICE / APPENDIX
Parametri / Parameters
Simbolo/symbol
Min
Std
Max
Schemi di configurazione
Diagrams of configuration
ConF (Config.)
0
0
5
Tabella 1 Menu CONFIGURAZIONE / Table 1 CONFIGURATION Menu
Parametri / Parameters
Simbolo/symbol
Min Std
Max Cf. 0 Cf. 1 Cf. 2 Cf. 3 Cf. 4 Cf. 5
Termostato differenziale
Differential thermostat
A31
(T1-T2)
3
5
30
Termostato massimo accumulo1
Max boiler 1 thermostat
A26
(TH3Max)
20
70
90
Termostato di integrazione
Integration thermostat
A25
(TH3min)
20
40
90
Termostato differenziale
Differential thermostat
A71
(T1-T4)
3
5
30
-
-
-
-
-
Termostato differenziale
Differential thermostat
A72
(T3-T4)
3
5
30
-
-
-
-
Termostato differenziale
Differential thermostat
A73
(T4-T3)
3
5
30
-
-
-
-
-
Termostato valvola sanitario
Sanitary valve thermostat
A22
(TH3)
20
30
90
-
-
-
-
-
Tabella 2 Menu PRINCIPALE / Table 2 MAIN Menu
