background image

E1447; 

051916

TIE DOWN ENGINEERING • 255 Villanova Drive SW • Atlanta, GA 30336

www.tiedown.com  (404) 344-0000  Fax (404) 349-0401 

Roof Zone Cart

Assembly Instructions

Model 65028

Important – Please Read These Instructions Fully Before Starting Assembly

If you need have damaged or missing parts, call the Customer Service: 404-344-0000

•  Check you have all the components listed on pages 2.
•  Remove all parts from the plastic bags and separate them into their groups.
•  Keep children and animals away from the work area, small parts could choke if swallowed.
•  Make sure you have enough space to layout the parts before starting.
•  Assemble on a hard level surface.
•  Assembly of the axles/frame will be easier with 2 people.

Instruction Sheet #08262

Page 1 of 4

TM

TM

Содержание Roof Zone PENETRATOR 65028

Страница 1: ...r missing parts call the Customer Service 404 344 0000 Check you have all the components listed on pages 2 Remove all parts from the plastic bags and separate them into their groups Keep children and animals away from the work area small parts could choke if swallowed Make sure you have enough space to layout the parts before starting Assemble on a hard level surface Assembly of the axles frame wi...

Страница 2: ...10250Z Flat Washer 1 zinc 6 8 10691 Cotter Key 3 16 x 2 6 9 10846 Tek Screw 14 x 1 zinc 4 10 10628 Nylock Nut 5 8 11 zinc Grade 2 3 11 10153Z Flat Washer 5 8 Zinc 3 12 10455 Carriage Bolt 5 8x11 x 5 2 13 70509 Pull Pin 5 8 x 3 1 14 65027 3 3 Bushing Cart Handle 2 15 65018 4 2Z Handle Pin 1 1 16 10456 Carriage Bolt 5 8 11 x 6 1 If you need have damaged or missing parts call the Customer Service 404...

Страница 3: ... Step 2 Lay the cart frame flat on hard ground Position axle frames front and back of the cart The axle frames will stand on thier own Step 3 Lift the rear cart frame may require two people Align the mounting holes with the axle and cart frame Insert carriage bolts thru cart frame and axle frame attach with washers and nylock nuts Use a 15 16 socket wrench to tighten the nuts bolts Step 4 Lift the...

Страница 4: ...n into the smaller inside round hole Install and split open cotter key on ONE end of the handle pin 15 slide on ONE washer Insert the handle pin through the handle guide bracket on the front axle Slide one bushing over the handle pin Position the handle assembly so the wheel brake bar is located on the bottom of the handle Align the handle assembly with the handle pin bushing Slide the handle pin ...

Отзывы: