Tidal Engineering Synergy Compact, Техническое руководство

Страница: 69 / 346

Synergy Controller Technical Manual, Revision H
Page 69
6.9 Graph Settings
The Graph Settings Paramters Control both the
chart on the Graph Screen as well as the chart on
the Main Screen.
6.10 LCD Settings
The LCD Brightness feature changes the brightness of the LCD touch screen. If your Synergy Controller is
at eye level or you work in very light conditions such as a room with direct sunlight, you may want to set the
LCD screen to a slightly darker setting. If your Synergy Controller is mounted in a location that requires the
operator to view the screen at a sharp angle or in a low light room, you can set the LCD to a brighter output.
Note that this function is controlled by a potentiometer on Synergy Micro and Synergy Micro V units. See the
figure in the
installation section of this manual.
6.11 Panel Lock
Panel Lock is a security feature that either partially or completely restricts access to the Synergy Controller.
This feature can protect a chamber from unauthorized access. When Panel Lock is enabled, access is only
permitted when the operator enters the password.
User access to specific controller areas can be restricted appropriately for each user function.
The enhanced Panel Lock feature provides 5 levels of access security:
1.
Administrator
2. Maintainer
3. Engineer
4. Operator
5. Unrestricted
The Synergy Controller user interface consists of the LCD Touch screen, eight Screen Selection buttons
below the LCD, and 10 Navigation and Control buttons to the right.
With the new Panel Lock features, each Screen Selection button is assigned a security level from the five
available levels. General Synergy controller screen features and Default user levels are summarized in the
table below.