Tidal Engineering Synergy Compact, Техническое руководство

Страница: 169 / 346

Synergy Controller Technical Manual, Revision H
Page 169
14.4.1 Setup Procedure
1. Locate the small square selector switch on the UUT Module
labeled Address Switch. Turn the dial on the switch to the proper
Module Address setting indicated in the table shown on the right.
MODULE NO SETTING
Module 1 1
Module 2 3
Module 3 5
Module 4 7
2. Locate the 9-pin male plug on the ribbon cable plugged into Olympic board P8.
3. Connect the 9-pin male connector from the ribbon cable to the RS-485 9-pin female connector located
on the UUT module.
4. Connect your T-Type Thermocouple input wires to the appropriate terminal blocks P2 thru P4 on the
UUT Module. Consult the Thermocouple Connection Tables on the UUT Module drawing for proper
terminations.
5. Be careful to route the thermocouple wires and the power supply cord safely through the appropriate
opening to avoid pinching.
6. Plug in the UUT Module wall power transformer to a 120 Volt
outlet.
Verify that the green LED on the UUT Module is illuminated. It
should be on steadily.
Notes:
-The table at the right shows the board power supply connections
to the P1 connector.
-The additional RS – 485 terminals labeled COMM shown in the
table on the right are not required for normal wiring since the DB-
9 connector provides these connections.
BOARD PWR SUPPLY and
RS-485 CONNECTION TABLE
P1 CONNECTOR
DESIGNATION TERMINAL
Board GND. P1 - 1
Board POWER P1 - 2
COMM RX –
Note 1
P1 - 3
COMM TX + P1 - 4
COMM TX - P1 - 5
COMM RX + P1 - 6
7. Turn on power to your test chamber. Once the Synergy Controller completes the boot-up procedure,
press the COMM Navigation key. Open the RS-485 folder to arrive at the screen below.
Configure RS-485 Mode and Station Address to the values displayed in the screen below by pressing on
each item. Make the changes in the screens that follow. Configure the Number of UUTs using the chart
on the right.
Address Selector
Switch