Tidal Engineering Synergy Compact, Техническое руководство

Страница: 137 / 346

Synergy Controller Technical Manual, Revision H
Page 137
11.1.1 Event Outputs Setup
Event Screen Setup
The Event Screen Setup Folder is used to
configure the Event Outputs Screen as follows:
1. Display Humidity Channel Event Outputs
2. Assign User friendly Event names to
each Event Output. See Section 6 for
more details.
11.1.2 Humidity Channel Event Outputs
The Humidity Channel Event Outputs are:
•
Use Drier
•
LEV 2
•
OT11 TPM
♦
Use Drier
The User Drier feature is used to change the dehumidification method. The Chamber defaults to
Dehumidify Coil. Select the
Use Drier method to achieve very low humidity.
The Use Drier mode is controlled by the settings in each Setpoint Step while the chamber is running a
program. To monitor the On/Off state of the Drier, go to the
Events\Event Output folder and observe
the LED indicator next to the Use Drier label. The light is red when the drier is active, gray when it is
inactive. To change the default dehumidification method for steady state operation go to the LEV1
folder under
Setup\L-Values\LEV1 and select the desired default method: Drier or Dehumidify Coil.