Tico Pro-Spotter, Руководство по обслуживанию

Страница: 121 / 211

PRO-SPOTTER AIR SYSTEM
TICO Manufacturing
Service Manual 8-7
Figure 8-8: Wet Air Tank (rear view)
5. Disconnect air lines (7—9). Close all openings using
caps and plugs.
6. Remove air release valve (10) as necessary.
Figure 8-9: Wet Air Tank (front view)
7. Disconnect air line (17). Close all openings using
caps and plugs.
8. Using an appropriate lifting device, support wet air
tank (16).
9. Remove cap screws (13 and 18), washers (14 and
19), lock nuts (15 and 20), lower bands (12), and wet
air tank.
10. Repair or replace components as necessary.
Inspection
• Clean all parts of dirt and debris.
• Inspect air lines, fittings, and valves for leaks, holes,
cracks, and loose connections. Replace parts found
to be unserviceable.
• Check all threaded components for damaged or
stripped threads. Repair light damage with thread
chasers. Replace parts found to be unserviceable.
Installation
Installation is the reverse of the removal procedure.
• Loosely apply bands (11 and 12) to wet air tank (16)
to aid in alignment.
• Position air release valve (10) for proper operation of
air release cable (4) and tighten bands.
• Verify operation of air release cables.
7 Air Line 12 Lower Band (2 used)
8 Air Line 13 Cap Screw (2 used)
9 Air Line 14 Washer (12 used)
10 Air Release Valve 15 Lock Nut (2 used)
11 Upper Band (2 used) 16 Wet Air Tank
12 Lower Band (2 used) 18 Cap Screw (2 used)
13 Cap Screw (2 used) 19 Washer (4 used)
16 Wet Air Tank 20 Lock Nut (2 used)
17 Air Line
7
TPS-098
9
8
10
16
11
12
15
13
14
17
TPS-099
16
13
18
19
20
12